| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| swaping out a cps http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=78175 |
Page 1 of 1 |
| Author: | steve@offroading.net [ Fri Jan 31, 2014 10:22 am ] |
| Post subject: | swaping out a cps |
Quick question, how long to swap out the crank sensor on a 2.8 and what bits need taking off to replace it. Getting some silly quotes on time & one place say you need to remove the rhs front suspension. Thanks |
|
| Author: | papaindigo [ Fri Jan 31, 2014 11:31 am ] |
| Post subject: | Re: swaping out a cps |
I can tell you where it is, see passenger side engine pictures at viewtopic.php?f=98&t=74594 However, that's "passenger side" on a left hand drive vehicle and I assume you are right hand drive so I cannot tell you what's in your way but clearly the steering might be. If you can get in there you will find 1 maybe 2 bolts holding the sensor heat shield in place. You can see 1 in the pictures and there is a place for another low down just below the hole in the heat shield and into the plate the engine stand is bolted to although on the engines that I've seen in that area the 2nd bolt is not there. Once the heat shield is off removal of the sensor is obvious. On a left hand drive vehicle it's a pretty quick and easy job. |
|
| Author: | steve@offroading.net [ Fri Jan 31, 2014 4:07 pm ] |
| Post subject: | Re: swaping out a cps |
thanks for that, will show the spanner monkey tomorrow when I drop it off. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|