Was working under my Jeep and noticed oil dripping off the bottom of the tranny. Followed the oil leak up and saw it dripping off the bottom of my turbo. Is this something I can fix with the elephant mod or Provent? To catch the excess oil... Or is this something else. Thanks, eh! (Ps how do you post pictures?) I got some, to explain it better.

_________________
2006 Jeep Liberty Sport CRD Black

This is something that the EHM or Pro-vent will not fix?

Are you sure it is coming from the bottom of the turbo? You can tighten the 2 bolts that hold the drain line on and see if that helps.

I had to reuse the crush washers for the turbo oil feed line when I replaced my turbo and it did leak around them. I have replaced them with new washers since.

_________________
Phil
2005 131k 3.7 Gasser (Lifted-CRD Springs, 4.10 Gears, F+R DTT, Teraflex 2wd Low, Skidrow/Mopar Skids, Rock Lizard Super Skinks, Goodyear Wrangler Authority 31x10.5-15)
2012 Triumph Tiger (TKC 80 Front Tire Heidnau K60 Rear, Crash Bars, Skid Plate, Bark Busters, Pelican Case Top Box)

If the oil is not leaking from the oil supply lines, but rather from the intake hose, then that can be solved with an EHM/Provent. Sometimes it's hard to tell where it's coming from. Take off the hose from the airbox to the turbo and inspect for tears or rotting.

_________________
05CRD: GDE Hot ECU & TCM tunes, Provent, Cat filter, Facet lift pump, TransGo kit, Florida TC, Samcos, stainless brake lines, HDS thermostat, Renegade light bar,
Bilstein adjustables, Al's Gen 4.5 Arms, 235/85-16 Duratracs, DTT rear, Elocker front, EVIC+TPMS, Turbo timer, McNally pillar gauges, Weeks Stage II kit.