I'd appreciate any information as the miniature bulb type used in the electronic overhead information console. There are three miniature bulbs with an attached plastic base used to light the overhead information buttons. Easy to service but I don't know if this a dealer only bulb.

Thanks in advance

2006 CRD Liberty

_________________
2006 CRD Limited
Green Diesel Engineering ECO Tune

Sounds like part# 04437661

_________________
2005 Liberty CRD Limited
DIY Garage Remanufactured Engine with GDE Full Torque Eco Tune from mile zero.
ARP Studs
Cummins Lift Pump
Transgo HD2 Reprogramming Kit
DIY Rebuilt Tranny Pump
Suncoast Torque Converter
2nd Generation Fuel Head
Sears P1 Battery
Hot Diesel Solutions Thermostat

The bulb for the two buttons on the right side of mine is out. Maybe I will take a look and see if I can figure it out.

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs

I was just looking over at the WJ forums and it seems like it may be a proprietary bulb.

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs

Parts fiche says Mopar Part # 04437661 which might cross to L0000192. Take a look here http://www.wjjeeps.com/lamps/lamps.htm . If so it's a pretty standard bulb.

_________________
Sold to LOST member my 05 Ltd, GDE Stg II turbo + TCM tune, SunCoast TC w. Transgo kit, Steiger window regulators, Samcos, Fumoto valve, 2nd gen filter head with Lub. Spec. bleeder, Hayden clutch & 11 blade fan, inverted spare, P-1 battery, BF Goodrich Long Trail TAs, Etecno1 glow plugs, timing belt at 50K miles/8 yrs

Thanks for the suggestions but unfortunately I believe that bulb is for the map lights. The bulb I'm speaking of is smaller than your fingernail on your little finger including the plastic base. You use a small flat screwdriver to turn 1/4 turn to remove the bulb/base from its socket. It is a filament type bulb (not LED). Mine also is the bulb for the two right side buttons. Gonna check with the dealer and see if I have any luck. Probably cost $20 ea if they are even available.

_________________
2006 CRD Limited
Green Diesel Engineering ECO Tune

OK I found them on ebay as well as from several UK suppliers:

http://www.ebay.com/itm/12v-1-2w-F4-8-B ... 1481153184

This apparently is the bulb number. You can see the image on the ebay link or by googling the bulb number. Anyone up for splitting a package of 10 with me?

_________________
2006 CRD Limited
Green Diesel Engineering ECO Tune