When I first purchased my CRD a couple of years ago, it had 235/75/16 street tread Michelins on stock sagged suspension with no rubbing of any kind...
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Anyone running 235/75 R16 tires on non-lifted http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=80510 |
Page 1 of 1 |
| Author: | fatweasel [ Tue Oct 28, 2014 9:37 am ] |
| Post subject: | Anyone running 235/75 R16 tires on non-lifted |
Hi Folks, Time for new tires. I am thinking about 235/75 R16 on my stock rims with no lift. Anyone have success with this size tire (no rubbing etc)? Diameter is a bit bigger than the stock 225/75 R16's. |
|
| Author: | WWDiesel [ Tue Oct 28, 2014 9:47 am ] |
| Post subject: | Re: Anyone running 235/75 R16 tires on non-lifted |
When I first purchased my CRD a couple of years ago, it had 235/75/16 street tread Michelins on stock sagged suspension with no rubbing of any kind...
|
|
| Author: | xhizzous [ Tue Oct 28, 2014 10:53 am ] |
| Post subject: | Re: Anyone running 235/75 R16 tires on non-lifted |
I Ran a set of silent armors in that size before they stopped making them. They rubbed barely on the back of the front tire... just enough to polish the plastic splash shield when turned sharply. I ran them with no problems other than that ... once they wore down they didnt rub anymore, It wasn't a problem. |
|
| Author: | tcoilburner [ Tue Oct 28, 2014 4:25 pm ] |
| Post subject: | Re: Anyone running 235/75 R16 tires on non-lifted |
I am running a second set of Continental Crosscontact LX2 in a p235/75r15. No problems. |
|
| Author: | ebbnflow [ Tue Oct 28, 2014 4:51 pm ] |
| Post subject: | Anyone running 235/75 R16 tires on non-lifted |
I run that size in a BF Goodrich long trail. I get a slight rub at full lock going over bumps with my original saggy suspension. It does not rub enough to harm the tires or the wheel wells though. I can't wait to get an OME lift and put on the moabs that have been collecting dust in my garage for too long. |
|
| Author: | jthomas999 [ Wed Oct 29, 2014 1:58 am ] |
| Post subject: | Re: Anyone running 235/75 R16 tires on non-lifted |
I run them and when I first got them they rubbed slightly on the plastic inside the fenderwells. A few minutes with a heat gun and some bending fixed that. 2006 Jeep Liberty CRD Limited. |
|
| Author: | Allen M. [ Wed Oct 29, 2014 7:05 pm ] |
| Post subject: | Re: Anyone running 235/75 R16 tires on non-lifted |
I ran that tire size for years, no rubbing issues at all. It does correct the speedometer to within 1/2 mph by several GPS units. Micelleins, Toyo never had a problem. |
|
| Author: | 65Corvair [ Wed Oct 29, 2014 8:42 pm ] |
| Post subject: | Re: Anyone running 235/75 R16 tires on non-lifted |
I ran that size in a Cooper ATR before I had a lift installed with no issues. Still no issues after the lift too. 
|
|
| Author: | woodtick [ Thu Oct 30, 2014 1:44 am ] |
| Post subject: | Re: Anyone running 235/75 R16 tires on non-lifted |
I'm running the hankook dynapro ATM's in a 235/75 R16. My suspension is sagging and still no rubbing. I had these on my last CRD too. Love em. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|