| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Lobe lift measurements http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=81054 |
Page 1 of 1 |
| Author: | AndrewCRD [ Thu Jan 08, 2015 12:06 am ] |
| Post subject: | Lobe lift measurements |
I was looking at how to measure cam shaft wear and some were saying to measure the diameter and the lobe length with a micrometer and substract. But then you need to know the factory specifications ... which as far as I found this engine has almost no available documentation. A lot of people seem to think visible wear is a good way to go, but just for my amusement id like to know the specifications for lobe lift. Anyone have any ideas ? maybe someone has a pair of new cams around they could measure ? |
|
| Author: | DOC4444 [ Thu Jan 08, 2015 8:58 am ] |
| Post subject: | Re: Lobe lift measurements |
If you have scoured the FSM to no avail, I would contact Keith. Best way to measure is with a dial indicator between centers, like in a lathe. Zero on the back side and read total lift on the nose. DOC |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|