| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| lift question http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=81569 |
Page 1 of 1 |
| Author: | devilkin4 [ Fri Mar 13, 2015 11:37 pm ] |
| Post subject: | lift question |
I know it's been asked before , but what kit is best bang for buck ? 1 Frankinlift , should I buy the complete kit with core charges? Or should my plates and hardware be good? 2 tommud 3.5 lift , which clevis should I get with this one? 3 rocky road 2 deluxe with control arms ? 4 jeepinbyal ome ? I can afford roughly 1500 Any help will be great |
|
| Author: | JeepMorrison [ Sat Mar 14, 2015 12:10 am ] |
| Post subject: | Re: loft question |
Not rocky road. The Franky, TM kit, or OME is all good. |
|
| Author: | JeepMorrison [ Sat Mar 14, 2015 12:11 am ] |
| Post subject: | Re: loft question |
Id go with the TM kit. Throw in bumpstops and you have it all |
|
| Author: | devilkin4 [ Sat Mar 14, 2015 4:31 pm ] |
| Post subject: | Re: lift question |
If I go with the TM lift , what clevis should I buy ? |
|
| Author: | JeepMorrison [ Sun Mar 15, 2015 1:52 pm ] |
| Post subject: | Re: lift question |
All that spacer is just a measurement device. |
|
| Author: | y2k_TA [ Sun Mar 15, 2015 7:53 pm ] |
| Post subject: | Re: lift question |
In my case with the TM lift I think that the 3/8 spacer is a little too much. I am ordering a set of 1/4 to use until my 790 springs settle a bit. Based on my recent upgrade, I would have a set of both 1/4 and 3/8 on hand incase the 3/8 gives control arm to coil contact issues. This was just my experience. Many go 3/8 with no issues at all. Mine is probably due to the 790 springs. |
|
| Author: | mass-hole [ Sun Mar 15, 2015 8:51 pm ] |
| Post subject: | Re: lift question |
Do you not need new cv's with the tommud due to the steeper angle on the CV. That's another $400 I think |
|
| Author: | JeepMorrison [ Sun Mar 15, 2015 11:03 pm ] |
| Post subject: | Re: lift question |
4" you are good on the CVs |
|
| Author: | CRD4U2 [ Fri Mar 20, 2015 2:14 pm ] |
| Post subject: | Re: lift question |
Why not the Rocky road one? They are using the OME spring also. And aren't the CV shorter on a CRD than the V6, so need less lift before they get damaged? |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|