LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Mystery noises after 2.5 in lift installed
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=82410
Page 1 of 1

Author:  CGman [ Fri Jun 19, 2015 9:01 am ]
Post subject:  Mystery noises after 2.5 in lift installed

Long story made short ( for now).

Just finished installing a full JBA 2.5 in silver package plus changed all the ball joints, tie rods and front hubs/ bearings. After a full alignment I'm driving it and it is okay on the highway but is making several sounds when hitting bumps. The most worrisome is a loud thunking/ popping sound coming from the drivers front suspension. Any ideas on what's happening?

Author:  flash7210 [ Fri Jun 19, 2015 10:16 am ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

Did you forget to tighten some bolts?
That would be the first thing I'd check.

Author:  John3:17 [ Fri Jun 19, 2015 10:27 am ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

? Was the upper control arm bolts tightened after the full weight of the vehicle was on the ground?

Author:  CGman [ Fri Jun 19, 2015 10:32 am ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

Just got off the phone with JBA, I think it may be that I torqued the UCA bolts in the extended position. If that doesn't fix it I'll disconnect the driver sway bar.

Author:  mass-hole [ Fri Jun 19, 2015 11:28 am ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

Other than that, how does it ride with the JBA's

Author:  CGman [ Fri Jun 19, 2015 11:45 am ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

I also changed from stock wheels/tires to Moabs with BFG KOs...so all I'm going to say right now is that it feels more like a JEEP and less like a nimble little SUV....probably because I don't want to scrap the wheel wells! :SOMBRERO:

Author:  MM53 [ Fri Jun 19, 2015 9:16 pm ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

Got some pics would love to see it. Hope it all works out let us know.

Author:  CGman [ Sun Jun 21, 2015 1:17 am ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

Retorqued the UCA and all the sway bar items ( just to make sure)...then the sway bar didn't want to cooperate :banghead: Ended up taking about a 10 mile test drive through varied conditions and then hit the road for a 12 hour drive to the mountains! The noise is GONE!

I will definitely be posting some pictures, but i wondered if I should do a full lessons learned write up also. ... :dizzy:

PS - put the old stock tires back on for the highway and the MPGs didn't look bad for the conditions.

Author:  MM53 [ Sun Jun 21, 2015 7:39 am ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

Yes full lessons learned write up would be good I am looking into getting the same lift.

Author:  funnyman06 [ Sun Jun 21, 2015 1:18 pm ]
Post subject:  Re: Mystery noises after 2.5 in lift installed

Im looking to do this setup as well, would love to see some pics of it! You are running the standard bilsteins correct or did you upgrade?

Author:  CGman [ Wed Jun 24, 2015 7:57 pm ]
Post subject:  Re: Mystery noises after 2.5 in lift installed - resolved

Before and after. (At the Great Sand Dunes in So Colorado)

Image

Image

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/