I'm looking for broken exhaust valves to run material analysis. Also for failure analysis as I want to have some quality valves made. Any help would be greatly appreciated. I will pay for shipping to Phoenix,Az

I have a set that I just removed from my head, replaced with new ones. None are broken, not sure if you might be interested in them. Approx 140000 miles on them

Sent from my XT1254 using Tapatalk

_________________
2006 Jeep Liberty CRD Limited - Rebuilt at 145K
GDE Eco Tune
Weeks 1+2
ARP Studs
New rockers + Valves
New #1 pistion and all connecting rods
New Crankshaft
Carter In-Tank Pump

One problem with that free shipping:

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Well THERES your problem!

I've got a new box of just-removed valves too, and I was going to contact Gerry and see if he wanted these for his testing too - that is the one that I'm waiting for at the moment. In the next week or so I should have 2 more sets of used-but-not-failed, you interested?

_________________
Proud supporting vendor of LOST Jeeps
TRAVELING CRD TECH. I come to you!
Need help? Just ask! I've taken it apart more than most.
Email jeep [at] maincomputer [dot] com - BOARD MESSAGING IS BROKEN
Over 225 CRDs currently driving with my valves, timing belt, rockers, or ARP Studs.
Bad noises = REALLY bad things.

Gonna be kinda hard to obtain broken valves when they are all embedded into piston heads.

_________________
U.S. Army Retired

Yeah, but the stem is what we are looking for.

_________________
Proud supporting vendor of LOST Jeeps
TRAVELING CRD TECH. I come to you!
Need help? Just ask! I've taken it apart more than most.
Email jeep [at] maincomputer [dot] com - BOARD MESSAGING IS BROKEN
Over 225 CRDs currently driving with my valves, timing belt, rockers, or ARP Studs.
Bad noises = REALLY bad things.