So I might have the opportunity to replace my fuel tank. I have a brand new lift pump I bought from a CRD owner and now might be the time for the upgrade.

Any reason I shouldn't? Has anyone had a negative experience? I figure enough time has gone by to poll the group.

I have an '06 CRD and I'm assuming I have the factory fuel filter head--will the increase in pressure from the tank cause anything to start leaking? Currently my fuel system is working well--except for the 1/4'' hole I just put in my fuel tank. Ha.

Thanks!

_________________
2006 CRD w/99,300 miles
F31 from a previous life
EHM @ 42K, ProVent @ 79K
GDE Eco Tune & TCM @ 46K
Engine mounts replaced @ 55k/93k, Timing Belt @ 90k
Lift Pump @ 97k
OME Lift, 1.5''
Kenwood TM-V71 Ham Radio / Cobra C75WX CB
Surf Racks

It is positively one of the best mods you can do to your Jeep CRD! There are no negatives, only positives! The motor will run better, idle smoother, and any leaks in the fuel system will be evident immediately...
It should have been there from the factory!!!!

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve

x2, should have come from the factory with a lift pump.

_________________
2005 CRD "Ol' Blue"
Red Ryder carbine-action, two hundred shot range model air rifle with a compass in the stock and this thing which tells time.
My build page- RL Komodo Rear and TJM Front Bumper, armored, lifted, JBA Steel D30, 4.10s and ARB air lockers.

1 negative I can think of. It a pain to get to the wires under the back seat. Otherwise all good over here.

_________________
05 CRD Sport - GDE EcoTune - Samcos - EGR Delete & Elbow kit - ARP Studs - Airtex E7181M

Speaking of wiring harnesses, this is the one that I have: part # 56047848AB

I've been reading various write-ups and I'm a little confused as to how much modding I'm going to have to do the the harness itself. Some write-ups mention needing to change the position of one of the pins.

From what I can tell, this comes from the '06 Gasser.

Does anyone have any insight into the one that I've got?

Thanks!

_________________
2006 CRD w/99,300 miles
F31 from a previous life
EHM @ 42K, ProVent @ 79K
GDE Eco Tune & TCM @ 46K
Engine mounts replaced @ 55k/93k, Timing Belt @ 90k
Lift Pump @ 97k
OME Lift, 1.5''
Kenwood TM-V71 Ham Radio / Cobra C75WX CB
Surf Racks