Does anyone know which size universal joint i need to get for the rear drive shaft on the CRD? CarQuest shows two which are different sizes, 3.220" and 3.622" but are not specific on the application.

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs

spicer 5_13119x 20$

sorry it is spicer part no# 5- 1310x

3.220 most likely. 1310 sized U joint. Easy to measure

_________________
2002 KJ Limited 3.7, 5.25" lift via coilovers, custom HD rear springs, 32.2" tires on moabs (soon 33s) 4.56/JBA diff, OX lockers front/rear, NP241OR, Parker Fab front/rear bumpers, rock rails and roof rack, Viair OBA.

2006 KJ sport 3.7, 4" Ironman lift, 32" tires, Parker Fab front/rear bumpers and rock rails.

I did get the spicer vs carquest branded



it was 3.220. I had no good way to measure it for sure since the outsides of the joint were recessed slightly and the actual "U"'s were like 3.7". I just went to carquest and held the new ones next to the drive shaft.

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs