Anyone have the custom PID numbers for the Torque Pro for our CRD's? Or can tell me where they can be found. Specifically the boost pressure, rail pressure and or MAP. I've been trying to find them and have read here where people are using them but no specifics. Any help would be greatly appreciated otherwise the Torque Pro APP is useless without them.

Thanks, John

_________________
John
2 X 2006 CRD Sport
Mine Light Blue, Hers Dark Blue
GDE ECO Tune
Fumoto
Samco Hoses

Rail pressure and boost/MAP are available as standard gauges. If you install the torque scan add on it also shows the pids.

_________________
Share your ideas freely at https://www.facebook.com/groups/libertydiesels/

You have to have the OBD adapter plugged in and the app connected to see all the available gauges/sensors that can be used. When you add a new gauge, all the available sensors will be highlighted in bright green. Using my tablet I can view:
speedometer
tachometer
MAP/boost
Intake Air Temperature
coolant temperature
fuel rail pressure
battery voltage

_________________
U.S. Army Retired

Make sure you are using the proper OBD profile for the Jeep. In my experience, you must go into the vehicle profile and tell it what to use otherwise it defaults to an incorrect one and you only get RPM. I believe it is ISO9141-2

With that said, the connection to the ECU is iffy at best. Mine drops connection pretty much every time i use it, and that is with a higher and OBDLink LX and a cheap chinese BT adapter.

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs

Thanks all, I will give your recommendations a try this weekend and let you know how it worked. I'm clearly in the default mode on the Torque Pro because all I get is RPM and all the things a phone can do in green.

_________________
John
2 X 2006 CRD Sport
Mine Light Blue, Hers Dark Blue
GDE ECO Tune
Fumoto
Samco Hoses