| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| rear Drive shaft universal joint http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=83088 |
Page 1 of 1 |
| Author: | mass-hole [ Fri Sep 18, 2015 7:15 pm ] |
| Post subject: | rear Drive shaft universal joint |
Does anyone know which size universal joint i need to get for the rear drive shaft on the CRD? CarQuest shows two which are different sizes, 3.220" and 3.622" but are not specific on the application. |
|
| Author: | rankom [ Fri Sep 18, 2015 7:38 pm ] |
| Post subject: | Re: rear Drive shaft universal joint |
spicer 5_13119x 20$ |
|
| Author: | rankom [ Fri Sep 18, 2015 7:42 pm ] |
| Post subject: | Re: rear Drive shaft universal joint |
sorry it is spicer part no# 5- 1310x |
|
| Author: | JeepMorrison [ Fri Sep 18, 2015 8:00 pm ] |
| Post subject: | Re: rear Drive shaft universal joint |
3.220 most likely. 1310 sized U joint. Easy to measure |
|
| Author: | mass-hole [ Fri Sep 18, 2015 8:50 pm ] |
| Post subject: | Re: rear Drive shaft universal joint |
rankom wrote: sorry it is spicer part no# 5- 1310x I did get the spicer vs carquest branded 4x4kayak2112 wrote: 3.220 most likely. 1310 sized U joint. Easy to measure it was 3.220. I had no good way to measure it for sure since the outsides of the joint were recessed slightly and the actual "U"'s were like 3.7". I just went to carquest and held the new ones next to the drive shaft. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|