This morning after starting up switched the fan on only to find it only worked on full power number (4) slower speeds did not work, this has never happened before is the problem likely to be in the switch or the fan motor?
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Heater fan fault http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=83243 |
Page 1 of 1 |
| Author: | joohn [ Mon Oct 12, 2015 8:56 am ] |
| Post subject: | Heater fan fault |
This morning after starting up switched the fan on only to find it only worked on full power number (4) slower speeds did not work, this has never happened before is the problem likely to be in the switch or the fan motor?
|
|
| Author: | papaindigo [ Mon Oct 12, 2015 9:13 am ] |
| Post subject: | Re: Heater fan fault |
Resistor that controls fan speed is dying. Copied from an old forum post "Yesterday speeds 1 and 2 stopped working on the cabin heater/AC fan on my 06 CRD and I found this thread. I got mine at Advanced Autoparts and it's ceramic covered as mentioned. The brand is BWD and part number is RU1040 or Standard Motor Products (SMP) RU347 and is listed for a 2001-2004 Chrysler Sebring. To get to the resistor open the glove box then press inward on the latch arms on the left and right side to let it drop down further. The resistor is right there held on by two 5/16 hex head screws. You need to pull out on the red tab about 1/4" to push the release and it required some pressure to get the red tap to pull out." The suggested replacement is heavier duty than stock OEM. |
|
| Author: | joohn [ Tue Oct 13, 2015 5:57 am ] |
| Post subject: | Re: Heater fan fault |
Ordered the part from ebay, thanks for the help. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|