| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Transmission code set today P0871 http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=84084 |
Page 1 of 1 |
| Author: | SargeIndustries [ Sun Feb 21, 2016 10:03 pm ] |
| Post subject: | Transmission code set today P0871 |
Anyone else have there transmission set code P0871? Just happened today on the way home. It will not shift into first gear anymore so it only starts out in second. The code refuses to clear. There are other posts about P0871 but there no one has ever said what solved there problem. Fun times. |
|
| Author: | flash7210 [ Sun Feb 21, 2016 10:31 pm ] |
| Post subject: | Re: Transmission code set today P0871 |
My guess would be a bad solenoid pack. But could also be a bad set of filters or bad pressure sensor or bad input/output speed sensors. |
|
| Author: | BlueLghtning [ Mon Feb 22, 2016 1:33 am ] |
| Post subject: | Re: Transmission code set today P0871 |
If you searched, you probably saw my thread where I was asking about the same code - viewtopic.php?f=5&t=84026 In my case, it's only if I manually try to use 2nd gear otherwise it's fine. Did yours happen in normal driving mode? I'm pretty sure mine is trying to start in 3rd when it throws that code on mine. Does yours shift to any other gears either or does it just get stuck there in that one gear? I also have a heck of a time clearing it when it happens, but eventually I get it cleared. Good luck and let me know what you find when you solve yours. |
|
| Author: | SargeIndustries [ Wed Feb 24, 2016 2:58 pm ] |
| Post subject: | Re: Transmission code set today P0871 |
My code went away and all is well for the moment. I had the scan gauge plugged in and that was probably causing TCM confusion. |
|
| Author: | WWDiesel [ Wed Feb 24, 2016 6:03 pm ] |
| Post subject: | Re: Transmission code set today P0871 |
Hope this is helpful? P0871 - OD Pressure Switch Rationality Fault This code is set if the OD pressure switch is open or closed at the wrong time in a given gear Faulty OD Pressure Switch, The Powertrain Control Module (PCM) uses three pressure switches to monitor the fluid pressure in the LR, 2/4, and OD clutch circuits. The pressure switches are continuously monitored for the correct states in each gear. A good transmission shop can test and / or replace the OD pressure switch. 
|
|
| Author: | SargeIndustries [ Mon Aug 22, 2016 12:04 pm ] |
| Post subject: | Re: Transmission code set today P0871 |
Replaced fluid, filters and solenoid pack and the problem still existed. I tried replacing the transmission line pressure sensor and it behaved so bizarrely that I was afraid to drive it. Switched back to the original sensor and decided to cut off the resistor I had installed years ago from a Transgo shift kit. I taped up the wires which I believe had been touching each other due to me not taping them up correctly from the resistor install years ago. I am happy to say that my problems have went away with the p0871 code. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|