LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Did I fry my cam position sensor?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=84344		 Page 1 of 1
Author:  DadsDiesel [ Thu Mar 31, 2016 6:18 pm ]
Post subject:  Did I fry my cam position sensor?
So,

The ongoing saga from this thread:
viewtopic.php?f=5&t=83956

I have been marinading the intake head/valve cover in diesel for a few days.... and, yes, I forgot to remove the cam position sensor and the MAP....

question is, have I screwed the pooch and killed both sensors?

I went to change the bathwater (so to speak) and soak the head a while to give it a good clean and when I pulled the intake from the bath, I noticed that neither sensor was removed from the intake! :banghead:

At this point I can only say :ROTFL: at myself...

The wife is begining to give me "the look" :roll:
Author:  olypopper [ Thu Mar 31, 2016 11:47 pm ]
Post subject:  Re: Did I fry my cam position sensor?
They are probably fine.......but you'll know when you try and fire it up.
Author:  Mountainman [ Fri Apr 01, 2016 11:20 am ]
Post subject:  Re: Did I fry my cam position sensor?
The map is the super sensitive one. Good thing someone tracked down the GM (I think) version that's the same part, and it's like $30 vs Chrysler $150? or something crazy. I agree though, probably fine, especially the cam since it's just a prox sensor, unless that juice got inside of it :grim:
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/