I'm seeing two different Transgo shift kits available for the 545RFE:

SK 45RFE
45RFE-HD2

What's the difference between the two and which one do I need for my CRD?

I'd get the HD2. It comes with more springs.
You dont need the resistor.

_________________
U.S. Army Retired

See my signature.

_________________
Silver 2006 KJ 2.8L CRD Limited:
GDE ECO Tune / Fumoto Valve / E-Tecno GX3123 7v Glow Plugs / 2nd Gen Fuel Head / Mishimoto RED Hoses / Rockers/Lifters @ 114k / Hayden FC + 11 Blade Nylon / Sears P1 Battery / Transgo 45RFE-HD2 Reprogramming Kit / Timken Front Bearings

Btw, how involving is to install it? The instructions are a bit brief.

_________________
2005 kj CRD, samco, suncoast tc, provent, Kennedy lift pump, GDE ECO full torque, 2nd gen filter head, 245/70/16 a/t tires, mopar light bar, fumoto oil valve, OEM Skid Plates, ARB Front bumper and HD OME, tru cool LPD47391 40k GVW tranny cooler (stock cooler delete), FF Dynamics e-fan and shroud, rocker arms replaced, HDS2 190F thermostat.

_________________
2005 Liberty CRD Limited
DIY Garage Remanufactured Engine with GDE Full Torque Eco Tune from mile zero.
ARP Studs
Cummins Lift Pump
Transgo HD2 Reprogramming Kit
DIY Rebuilt Tranny Pump
Suncoast Torque Converter
2nd Generation Fuel Head
Sears P1 Battery
Hot Diesel Solutions Thermostat

Mike, you're the man! Thanks a lot!

_________________
2005 kj CRD, samco, suncoast tc, provent, Kennedy lift pump, GDE ECO full torque, 2nd gen filter head, 245/70/16 a/t tires, mopar light bar, fumoto oil valve, OEM Skid Plates, ARB Front bumper and HD OME, tru cool LPD47391 40k GVW tranny cooler (stock cooler delete), FF Dynamics e-fan and shroud, rocker arms replaced, HDS2 190F thermostat.

Pull pan, pull filters .. pull valve body and take it apart.

you wont be able to do the trans pump mod or use the large snap ring without pulling the trans so you can get into the front drum. If you do, make sure you keep everything in order and count the snap rings and such so you can replace the right one.

If you are just using the springs it should be a cakewalk. You will also need to have a dealer or someone with the right tool to a "relearn" on the trans to make it learn how to shift properly again.

_________________
05 CRD Limited GDE Hot Tune, EuroTC, ARPs, Full EGR Del, IDParts Hoses, Etecno 7v GP, OME 790 Bilstein 916front, OME948 OME N132Lrear, JBA A-Arms, 245/75/16 Duratracs+Moabs, Renegade roof lights, Curt Front Hitch, BTF Kryptonite Diff, JCR Stage2 Rails, SkidRow Skids, HDS Tstat,

Sold 06 CRD Limited K&N, EHM, ORM, EuroTC, TransgoKit, Samcos