| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Sealing CP3 return line http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=84373 |
Page 1 of 1 |
| Author: | Brumbles88 [ Tue Apr 05, 2016 3:41 pm ] |
| Post subject: | Sealing CP3 return line |
Finally got my crd running, turns out a bad injector was keeping it from building pressure. Anyways now that it runs I have a leak at the fuel return bridge. During disassembly I broke the little nipple off the plastic bridge, figure I would try the brass fitting mod rather than purchasing a whole new bridge for $105. It appears the plastic liner in the cp3 return line is preventing the barb fitting and hoe clamp from creating a good seal. Any suggestions on how to seal the leak? |
|
| Author: | rankom [ Thu Apr 07, 2016 8:53 pm ] |
| Post subject: | Re: Sealing CP3 return line |
well its your choice brass or plastic both will do the job . so did you purchase a new injector or used ? they are very expensive so usually people don't include them as failure points i guess good reason is a cost . good to hear runs again. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|