I installed weeks stage 1&2 on my 06 and now it will start and run 5-10 minutes and shuts down, unhook battery let computer reset it will do same. Help please

Any codes?
If you haven't replaced the fuel filter, now might be the time.
Check fuel filter head for leaks and check the two wire connectors for signs of fuel leak.

I doubt the problem is related to the EGR delete. Sounds more like a fuel problem.

_________________
U.S. Army Retired

Any check engine light?

If not I had a similar issue and the crank sensor was at fault.

There is a bracket behind and above the FCV/EGR VALVE . Make sure the wire bundle behind it is not pinched and grounding out.


That issue caused my crd to be stranded for over a week and a half. Frayed clamped wires.

_________________
Got Sheep?

2005 Jeep Liberty CRD 271'000+ KM's, ORM, Muffler Delete, MOROSO oil/air separator unit, 1000 CA battery, ARB Bull bumper, OME coils/shocks 2" lift. Custom BushRoo roof rack & Bush Joey hitch rack. Mobil1-301 oil filter & Mobil 1 DELVAC ESP 0W40 Full Synthetic oil, custom rear hatch cargo rack. RACOR 245 filterhead

Yes I changed fuel filter and have checked for wires pinched, I had a check engine light before I did delete kit, I'm thinking it's a fueling issue not sure where to start though