Since i am in the process of rebuilding my engine i figure i should replace the exhaust valves while its all apart. Is this something i can do myself or do i need to take it to a shop to do? Also is it worth replacing the intake valves also?

_________________
2006 Jeep Liberty CRD Limited - Rebuilt at 145K
GDE Eco Tune
Weeks 1+2
ARP Studs
New rockers + Valves
New #1 pistion and all connecting rods
New Crankshaft
Carter In-Tank Pump

You can do it yourself, but is best done by a machine shop that has all the proper tools to remove old valves, grind seats and lap new valves into seats for proper sealing...VERY IMPORTANT!!!!

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve

Thats what i was looking for, Thanks! It seemed easy enough to physically replace them but i wasn't sure if there was more to it. Looks like i will be bringing it to the shop when i bring my crank. Thanks Again

_________________
2006 Jeep Liberty CRD Limited - Rebuilt at 145K
GDE Eco Tune
Weeks 1+2
ARP Studs
New rockers + Valves
New #1 pistion and all connecting rods
New Crankshaft
Carter In-Tank Pump