| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| ECM Wire Connectors - P2294 Related http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=85036 |
Page 1 of 1 |
| Author: | seanscrd [ Fri Jul 29, 2016 8:13 pm ] |
| Post subject: | ECM Wire Connectors - P2294 Related |
Has anyone had the joy of replacing any of the Bosch wire connectors in the ECM Connector yet? I'm looking at a couple wires that use the BDK/BSK connectors. Or at least that's the information that I've found so far says. The two wires specifically are #4 and #52 on C1. The bigger 96 way connector on the ECM. Anyhow, I'm looking for a good, cheap, quick, reliable(as in send me the right thing) resource. Much thanks in advance for any and all help! Sean |
|
| Author: | flash7210 [ Fri Jul 29, 2016 8:40 pm ] |
| Post subject: | Re: ECM Wire Connectors - P2294 Related |
I think p2294 is the fuel rail pressure solenoid. I'd start by replacing the harness connector at the rail pressure solenoid. I had a similar problem with my fuel quantity solenoid in the CP3. After testing the solenoid, the harness, and the ECU connection, I thought for sure that my ECU was bad. Thankfully it turned out to be a intermittent open circuit in the harness connector at the solenoid. A cheap and easy fix. |
|
| Author: | seanscrd [ Fri Jul 29, 2016 9:28 pm ] |
| Post subject: | Re: ECM Wire Connectors - P2294 Related |
Yup that's the one. Already tried that. Took the drastic step of opening up the harness to replace the wire set for that plug. Scary! Going to pull the ECM out right now and clean all the pins off just in case that contributing. This has been an on again off again problem for about a month now. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|