LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Installed Weeks kits 1 and 2...what about the Provent?
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=85069		 Page 1 of 1
Author:  vertrx7 [ Fri Aug 05, 2016 10:19 pm ]
Post subject:  Installed Weeks kits 1 and 2...what about the Provent?
If we installed the Weeks kit, can we get rid of the Provent? Previous owner placed it on passenger side where it belongs, I think. It has one hose which goes to a large diameter valve of some kind on the top of the motor. One hose goes down the side of the motor. Is it as simple...if we can remove it...as connecting the valve on the top of the motor to where the bottom hose goes on the side of the motor?
Reason for the question is that its really in the way, especially since we now need to remove and replace the crankshaft sensor on that side of the motor.

Thanks for any help in advance.
Author:  WWDiesel [ Sat Aug 06, 2016 1:39 pm ]
Post subject:  Re: Installed Weeks kits 1 and 2...what about the Provent?
vertrx7 wrote:
If we installed the Weeks kit, can we get rid of the Provent? Previous owner placed it on passenger side where it belongs, I think. It has one hose which goes to a large diameter valve of some kind on the top of the motor. One hose goes down the side of the motor. Is it as simple...if we can remove it...as connecting the valve on the top of the motor to where the bottom hose goes on the side of the motor?
Reason for the question is that its really in the way, especially since we now need to remove and replace the crankshaft sensor on that side of the motor.

Thanks for any help in advance.

Do not remove the ProVent, all Jeep CRD engines should have one on them if the owner has not already installed one!!! They should have been installed in the factory to start with.... :banghead:
The outlet pipe of the ProVent should be connected to the turbo intake boot to provide some negative pressure on the CCV for it to function correctly! The ProVent will filter out any liquids and catch them which will allow you to drain them out periodically.
EHM mode is BAD!!!
Read this thread and make your own decision, it is kind of long but very informative.
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=80491&hilit
Author:  vertrx7 [ Sat Aug 06, 2016 3:50 pm ]
Post subject:  Re: Installed Weeks kits 1 and 2...what about the Provent?
Thank you for your response. I thought with the Weeks kits, it would eliminate the issue of the oil blowby. Not so is what I'm understanding then. I think then I'll find some more flexible hoses then as the ones installed make access to that crank sensor very difficult since they don't want to move all that much.
Author:  WWDiesel [ Sat Aug 06, 2016 9:30 pm ]
Post subject:  Re: Installed Weeks kits 1 and 2...what about the Provent?
If you read the thread I posted, a lot of the blowby is from the vacuum pump internal discharge combined with the normal blowby of the piston rings.... A ProVent is a very nice piece of equipment to catch and filter all this blowby and keep it out of your intake, turbo, and keep it from accumulating liquid oil in the Charge Air Cooler.....
It really makes a huge difference and is one of the better mods I did to my Jeep CRD early on based on advised from members on this forum......
No other CCV mod comes close and an EHM is not a good option!!!!! :banghead:
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/