It is currently Sun Oct 12, 2025 10:22 am

View unanswered posts | View active topics


Board index » Jeep CRD / E85 / Alternative Fuels » Liberty CRD...Love that Torque!!!

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
jeeplibertycrd
 Post subject: Any suggestions on getting pinch bolt out on ball joint
PostPosted: Sat Aug 27, 2016 11:56 am 
Offline
LOST Newbie

Joined: Wed Jul 13, 2016 10:09 pm
Posts: 17
I tried hammering with brass punch
Top
 Profile  
 
flash7210
 Post subject: Re: Any suggestions on getting pinch bolt out on ball joint
PostPosted: Sat Aug 27, 2016 12:18 pm 
Offline
LOST Addict

Joined: Fri Jun 22, 2007 11:43 am
Posts: 4962
Location: Green Cove Springs FL
You can use a pickle fork (a.k.a. Ball joint separator).

But what I do is hammer the side of where the ball joint stud goes into.
Usually one or two hard hits and it pops free.

_________________
U.S. Army Retired
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » Jeep CRD / E85 / Alternative Fuels » Liberty CRD...Love that Torque!!!

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 52 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com

Advertisements by Advertisement Management