Autozone has this:

http://www.autozone.com/engine-manageme ... ckfit=true

But there has to be a cheaper source out there, I think its an EV6 connector, can anyone confirm?

If so there are some other options out there:

https://www.amazon.com/GooDeal-USCAR-In ... +connector

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Rock auto is where I got mine. Under 4 bucks. You have to pay for shipping though. The have super cheap wiper blades as well. I always check the blades on all my cars when I make an order. I get oil filters there as well.

For this cheap stuff it might be cheaper at a local store but when you get several items it makes up for the shipping.

_________________
06 Liberty CRD--cheap lift and a Magniflow
04 Expedition--5.4L 4x4 Eddie Bauer
90 Bronco--5.0L another Eddie Bauer
81 Austin Mini--automatic, 1 liter of raw power
69 Cougar--398" of pure torque, when it ran

I have never had good luck at Autozone with any electrical related parts

_________________
2006 Jeep Liberty CRD 142,000 miles New engine 2-2014, Green Eco tune, FS2500 bypass filter Weeks elbow, European Torque converter, brakes front UCA's wheel bearing and front hubs. Front hitch OEM lift pump
98 K2500 Suburban 6.5td
96 K1500 " 6.5td
95 2 door Tahoe 6.5td
94 K3500 cc srw 5 speed 6.5td
91 International Model 6 speed spicer 4700

I got the StandardMotor S799 pigtail + rear ABS sensor from Amazon for $25 free shipping.

_________________
U.S. Army Retired

I'm looking to rebuild the harness with new plugs and wire to up under the seat, so I'm looking for 2 new plugs.

I figured these connectors were common enough in automotive applications that I ought to be able to get new for less than $40 for 2.

As a side note I have new sensors but I read 2200 ohms (about right for sensor only), to one rear sensor, and 7000 ohms to the other rear, so despite the fact that circuit has good continuity, I fear I have an internal corrosion issue.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

I ended up replacing the wires from the right rear sensor to the connector under the seat.

_________________
06 Liberty CRD--cheap lift and a Magniflow
04 Expedition--5.4L 4x4 Eddie Bauer
90 Bronco--5.0L another Eddie Bauer
81 Austin Mini--automatic, 1 liter of raw power
69 Cougar--398" of pure torque, when it ran

If you need the coupling for low amp applications, I'd use one of the below. First will make you spend the time to connect the wires to the pins, which takes a bit. I used both choices and so far so good, I have a 300w light bar on the ram and I used these connectors, obviously the high gauge wire is about an inch long, the rest is 10ga.

MUYI 10 Kit Set 2 Pin Way Terminals Connector Plug 1.5mm Waterproof Electrical Wire Connector Plug 18AWG https://www.amazon.com/dp/B014IU2EE2/re ... 1xb20DDMRT

E Support 2 Pin Way Car Auto Waterproof Electrical Connector Plug Socket Kit with Wire AWG Gauge Marine Pack of 5 https://www.amazon.com/dp/B0144CFW0M/re ... 1xbKRC9VES

_________________
2005 kj CRD, samco, suncoast tc, provent, Kennedy lift pump, GDE ECO full torque, 2nd gen filter head, 245/70/16 a/t tires, mopar light bar, fumoto oil valve, OEM Skid Plates, ARB Front bumper and HD OME, tru cool LPD47391 40k GVW tranny cooler (stock cooler delete), FF Dynamics e-fan and shroud, rocker arms replaced, HDS2 190F thermostat.

While I appreciate the feedback neither of those are the correct plug for the speed pickups.

This is the connector for the speed sensors, I believe it is EV6.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

You're right, sorry, I missed that. I searched on Amazon "ev6 connector" and I got few good priced items, they come with wires.

GooDeal 8pcs EV6 EV14 USCAR Fuel Injector Connector Pigtail Wire for Dodge LS2 LS3 GM Ford https://www.amazon.com/dp/B00YGAJZYC/re ... 2xb0931PYR



Doesn't look exactly like what you need, but I'm pretty sure you can get them on amazon/eBay, especially if you know the type of connector. I also wonder if you can buy a used harness from eBay and get the connectors you need from that.

_________________
2005 kj CRD, samco, suncoast tc, provent, Kennedy lift pump, GDE ECO full torque, 2nd gen filter head, 245/70/16 a/t tires, mopar light bar, fumoto oil valve, OEM Skid Plates, ARB Front bumper and HD OME, tru cool LPD47391 40k GVW tranny cooler (stock cooler delete), FF Dynamics e-fan and shroud, rocker arms replaced, HDS2 190F thermostat.