LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
Source for rear speed sensor harness plug? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=85256 |
Page 1 of 1 |
Author: | Sir Sam [ Mon Sep 12, 2016 9:13 am ] |
Post subject: | Source for rear speed sensor harness plug? |
Autozone has this: http://www.autozone.com/engine-manageme ... ckfit=true But there has to be a cheaper source out there, I think its an EV6 connector, can anyone confirm? If so there are some other options out there: https://www.amazon.com/GooDeal-USCAR-In ... +connector |
Author: | 69Hcode [ Mon Sep 12, 2016 10:19 am ] |
Post subject: | Re: Source for rear speed sensor harness plug? |
Rock auto is where I got mine. Under 4 bucks. You have to pay for shipping though. The have super cheap wiper blades as well. I always check the blades on all my cars when I make an order. I get oil filters there as well. For this cheap stuff it might be cheaper at a local store but when you get several items it makes up for the shipping. |
Author: | jrsavoie [ Mon Sep 12, 2016 10:30 am ] |
Post subject: | Re: Source for rear speed sensor harness plug? |
Sir Sam wrote: Autozone has this: http://www.autozone.com/engine-manageme ... ckfit=true But there has to be a cheaper source out there, I think its an EV6 connector, can anyone confirm? If so there are some other options out there: https://www.amazon.com/GooDeal-USCAR-In ... +connector I have never had good luck at Autozone with any electrical related parts |
Author: | flash7210 [ Mon Sep 12, 2016 12:06 pm ] |
Post subject: | Re: Source for rear speed sensor harness plug? |
I got the StandardMotor S799 pigtail + rear ABS sensor from Amazon for $25 free shipping. |
Author: | Sir Sam [ Mon Sep 12, 2016 2:16 pm ] |
Post subject: | Re: Source for rear speed sensor harness plug? |
I'm looking to rebuild the harness with new plugs and wire to up under the seat, so I'm looking for 2 new plugs. I figured these connectors were common enough in automotive applications that I ought to be able to get new for less than $40 for 2. As a side note I have new sensors but I read 2200 ohms (about right for sensor only), to one rear sensor, and 7000 ohms to the other rear, so despite the fact that circuit has good continuity, I fear I have an internal corrosion issue. |
Author: | 69Hcode [ Mon Sep 12, 2016 8:47 pm ] |
Post subject: | Re: Source for rear speed sensor harness plug? |
I ended up replacing the wires from the right rear sensor to the connector under the seat. |
Author: | thermorex [ Tue Sep 13, 2016 9:22 am ] |
Post subject: | Re: Source for rear speed sensor harness plug? |
If you need the coupling for low amp applications, I'd use one of the below. First will make you spend the time to connect the wires to the pins, which takes a bit. I used both choices and so far so good, I have a 300w light bar on the ram and I used these connectors, obviously the high gauge wire is about an inch long, the rest is 10ga. MUYI 10 Kit Set 2 Pin Way Terminals Connector Plug 1.5mm Waterproof Electrical Wire Connector Plug 18AWG https://www.amazon.com/dp/B014IU2EE2/re ... 1xb20DDMRT E Support 2 Pin Way Car Auto Waterproof Electrical Connector Plug Socket Kit with Wire AWG Gauge Marine Pack of 5 https://www.amazon.com/dp/B0144CFW0M/re ... 1xbKRC9VES |
Author: | Sir Sam [ Wed Sep 14, 2016 9:43 am ] |
Post subject: | Re: Source for rear speed sensor harness plug? |
thermorex wrote: If you need the coupling for low amp applications, I'd use one of the below. First will make you spend the time to connect the wires to the pins, which takes a bit. I used both choices and so far so good, I have a 300w light bar on the ram and I used these connectors, obviously the high gauge wire is about an inch long, the rest is 10ga. MUYI 10 Kit Set 2 Pin Way Terminals Connector Plug 1.5mm Waterproof Electrical Wire Connector Plug 18AWG https://www.amazon.com/dp/B014IU2EE2/re ... 1xb20DDMRT E Support 2 Pin Way Car Auto Waterproof Electrical Connector Plug Socket Kit with Wire AWG Gauge Marine Pack of 5 https://www.amazon.com/dp/B0144CFW0M/re ... 1xbKRC9VES While I appreciate the feedback neither of those are the correct plug for the speed pickups. This is the connector for the speed sensors, I believe it is EV6. ![]() |
Author: | thermorex [ Thu Sep 15, 2016 12:19 am ] |
Post subject: | Re: Source for rear speed sensor harness plug? |
Sir Sam wrote: thermorex wrote: If you need the coupling for low amp applications, I'd use one of the below. First will make you spend the time to connect the wires to the pins, which takes a bit. I used both choices and so far so good, I have a 300w light bar on the ram and I used these connectors, obviously the high gauge wire is about an inch long, the rest is 10ga. MUYI 10 Kit Set 2 Pin Way Terminals Connector Plug 1.5mm Waterproof Electrical Wire Connector Plug 18AWG https://www.amazon.com/dp/B014IU2EE2/re ... 1xb20DDMRT E Support 2 Pin Way Car Auto Waterproof Electrical Connector Plug Socket Kit with Wire AWG Gauge Marine Pack of 5 https://www.amazon.com/dp/B0144CFW0M/re ... 1xbKRC9VES While I appreciate the feedback neither of those are the correct plug for the speed pickups. This is the connector for the speed sensors, I believe it is EV6. ![]() You're right, sorry, I missed that. I searched on Amazon "ev6 connector" and I got few good priced items, they come with wires. GooDeal 8pcs EV6 EV14 USCAR Fuel Injector Connector Pigtail Wire for Dodge LS2 LS3 GM Ford https://www.amazon.com/dp/B00YGAJZYC/re ... 2xb0931PYR ![]() Doesn't look exactly like what you need, but I'm pretty sure you can get them on amazon/eBay, especially if you know the type of connector. I also wonder if you can buy a used harness from eBay and get the connectors you need from that. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |