| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| P1648 wont go away http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=85500 |
Page 1 of 1 |
| Author: | racertracer [ Thu Oct 27, 2016 1:13 am ] |
| Post subject: | P1648 wont go away |
I charged the battery while it was still in the car and now I have an engine code that will not go away. 2006 CRD. P1648 Glow Plug Module Internal. I went ahead and replaced the glow plug module and the light didn't go away, the light is still on. Checked all the glow plugs and they tested good. Engine light is still on, any ideas? |
|
| Author: | Billwill [ Tue Nov 01, 2016 5:28 am ] |
| Post subject: | Re: P1648 wont go away |
racertracer wrote: I charged the battery while it was still in the car and now I have an engine code that will not go away. 2006 CRD. P1648 Glow Plug Module Internal. I went ahead and replaced the glow plug module and the light didn't go away, the light is still on. Checked all the glow plugs and they tested good. Engine light is still on, any ideas? I believe that the Glow Plug Module has to be re-programmed when the plugs are changed between 7 volt and 5 volt so is your module programmed correctly.... or is it the ECM that gets re-programmed? Check that there is a good ground on pin 7 and +12 volts on pin 11 My 2002 CRD 11 volt plugs does not have a module..just two large relays! |
|
| Author: | racertracer [ Sun Dec 18, 2016 7:27 am ] |
| Post subject: | Re: P1648 wont go away |
I may have a grounding problem. I've located a few connections in the engine compartment that I've cleaned and reconnected......anyone have a list of where all the grounding connections are located? Where to look? |
|
| Author: | racertracer [ Sun Dec 18, 2016 8:11 pm ] |
| Post subject: | Re: P1648 wont go away |
Thanks, WW... I'll check it tomorrow. |
|
| Author: | racertracer [ Tue Dec 20, 2016 2:18 pm ] |
| Post subject: | Re: P1648 wont go away |
Code p1648 returned. |
|
| Author: | WWDiesel [ Tue Dec 20, 2016 3:05 pm ] |
| Post subject: | Re: P1648 wont go away |
You may have already seen this? From my notes: "P1648 - glow plug internal failure ( code is reset after X cycles by ECU)" |
|
| Author: | racertracer [ Mon Jan 02, 2017 10:01 pm ] |
| Post subject: | Re: P1648 wont go away |
I may have found the problem at the wire harness behind the fuel head. I Removed the harness wrapping and exposed the wires, moved them a bit and voila... the code went off. Not sure which wire it is yet but I am on the verge of victory. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|