Just finishing up putting my jeep back together, hoping to get it started tonight. I'm in the process of putting the wiring harness back and I have 2 connections that I'm not sure about.
The first one is two black wires that look like they get bolted to a stud. Is this part of the starter or was this something from the egr system that is no longer needed?

The second connector is a green connector that is on the same wiring run as the crankshaft position sensor this is the Last connector on this run. Any ideas where this goes?

Sent from my XT1254 using Tapatalk

_________________
2006 Jeep Liberty CRD Limited - Rebuilt at 145K
GDE Eco Tune
Weeks 1+2
ARP Studs
New rockers + Valves
New #1 pistion and all connecting rods
New Crankshaft
Carter In-Tank Pump

Figured it out. The first one is a ground and the second one is the oil pressure sensor.

_________________
2006 Jeep Liberty CRD Limited - Rebuilt at 145K
GDE Eco Tune
Weeks 1+2
ARP Studs
New rockers + Valves
New #1 pistion and all connecting rods
New Crankshaft
Carter In-Tank Pump