| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Getting live data from a crd? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=86040 |
Page 1 of 1 |
| Author: | 38turbo [ Wed Jan 25, 2017 10:16 pm ] |
| Post subject: | Getting live data from a crd? |
What are you guys using to get live data... ? My snap on solus will read data but only updates like every 30 seconds... I cannot get live or even close to live data... tried my buddies matco scanner same issues maybe a little faster but would lock up all the time would have to back out and restart data stream.? Working on an 06 with over boost under boost codes actuator seems to be working correctly. Have removed turbo cleaned vanes... intake boot between turbo and air box good. No intercooler or hose leaks. Map sensor new. Monitored the vacuum to the actuator with a vacuum gauge and seems to be doing what it's supposed to... really would help to read live data... any help is appreciated! |
|
| Author: | flash7210 [ Wed Jan 25, 2017 11:28 pm ] |
| Post subject: | Re: Getting live data from a crd? |
Android phone/tablet + ELM327 bluetooth adapter + torquepro app Live data from: tach, speedo, MAP, IAT, coolant temp, fuel rail pressure, and a few others |
|
| Author: | Sir Sam [ Thu Jan 26, 2017 1:10 am ] |
| Post subject: | Re: Getting live data from a crd? |
I have a wifi code reader that reads realtime, the DRBIII can also read realtime. bluetooth elm327 for android is less than $10 for hardware. Wifi elm327 for iphone is about $30. DRBIII is about $3000. |
|
| Author: | 38turbo [ Wed Feb 01, 2017 6:53 pm ] |
| Post subject: | Re: Getting live data from a crd? |
Thanks guys the elm 327 and the torque app is helping not as much data options as I would like but it is live data |
|
| Author: | Sir Sam [ Wed Feb 01, 2017 8:32 pm ] |
| Post subject: | Re: Getting live data from a crd? |
38turbo wrote: Thanks guys the elm 327 and the torque app is helping not as much data options as I would like but it is live data torque pro should give you more options over the free version. |
|
| Author: | mass-hole [ Thu Feb 02, 2017 11:38 am ] |
| Post subject: | Re: Getting live data from a crd? |
38turbo wrote: Thanks guys the elm 327 and the torque app is helping not as much data options as I would like but it is live data It definitely wont show you everything, but most of the major sensors are in there. Make sure you have the appropriate OBD protocol selected under the vehicle profile: ISO 9141-2. If you dont it will default to some other protocol and it will only show you RPM and one or two other things. IAT, MAP, RPM, Fuel Rail Pressure, MAF, Coolant Temp, Engine Load etc should all be there. I've never been able to see any transmission related sensors but I believe its because our Lib's are some kind of Hybrid communication system where the ECU works in one way and the rest of the computers work in another. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|