Good day.

I am looking to replacing my aging sway bar links. I do have OME h/d setup in the front and m/d in the rear. Will this affect my choice of links or are the original sized links just fine? Also are there any other choices for links or are Mopar originals fine to replace with.

Thanks all for the (hopefully) future responses.

Peace.

I mean if you wanna spend a little cash then you could go with the JBA disconnecting links. They are adjustable so you could get your sway bar back to the stock angle.

I don't have much experience off-road but I will tell you that when I disconnected my front sway bar to help me check the bump stop height it allowed a hell of a lot more articulation. Instead of the front barely budging and stuffing the opposite rear wheel, they worked together the front moved well.


Sent from my iPhone using Tapatalk

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs