Ok looking for suggestions. Installed the Weeks 1&2 about two months ago and did a fuel filter at the same time. Now the Jeep runs fine until warm and it starts a flashing ETC "lighting bolt" as well as a flashing low fuel light and it cuts out and nearly stalls. I thought this was an air in fuel problem but have fixed that and see no air in the system. Thought maybe it was a crank sensor since it happens when it warms up but I replaced it and it made no difference. Only codes it shows are for EGR circuit.

Can't find anything online about the flashing low fuel light. Any suggestions?

I have an occasional TPS (lightning bolt) light also I have not figured out yet, replaced throttle pedal assy and no help.
Put the flashing low fuel could be bad ground or broken wire.

_________________
06 CRD Limited/#2
Full OME suspension/Sway Bar Disconnects
ARB Bumper/ LEDs
SS Cat Back
Warn 8000
KC HID Daylighters (2)
Sasquatch EGR delete kit
ARP stud kit
Safari Snorkel
Suncoast TC
Alpine/ JL Audio
Clifford Remote Start
Netto Terra Grapplers 265/75/16
GDE Hot
Lift Pump
Sasquatch Battery Kit

Inspect your wiring harness thoroughly where it comes through the firewall.

Also, change your ASD relay.

_________________
Silver 2006 KJ 2.8L CRD Limited:
GDE ECO Tune / Fumoto Valve / E-Tecno GX3123 7v Glow Plugs / 2nd Gen Fuel Head / Mishimoto RED Hoses / Rockers/Lifters @ 114k / Hayden FC + 11 Blade Nylon / Sears P1 Battery / Transgo 45RFE-HD2 Reprogramming Kit / Timken Front Bearings