five7driver wrote:
Hey Slvdc1, I'm having the exact same problem. Did you ever find a fix?
No! The Jeep has been in storage while I was abroad so I haven't had a change to dig into this further...until yesterday.
I picked up a replacement regulator and plugged it in to test...same issue; only rolls down and not up.
So I took another look at the wires in the door jamb and completely removed the rubber boot and probed the connectors. The wiring in the hinge is fine. I get the same result from the door jamb connector as I do at the window motor connector: 12V in one direction and 0.5v in the other direction using the master window switch.
I looked up the wiring harness and I'm now working on a theory that the wire used for going up must be shorted to ground (which would explain how I fried my prior window switch)
I'm going to pull the front passenger seat tonight and pull back the carpeting for further diagnosis. I have a feeling that the wiring harness was accidentally pinched under the passenger seat when I was doing that swap from KK seats
Have you had any luck?
Best,
Shane