Gents and Gals,
After a few years, I am glad you are here, but not glad to be back.
Last week, my daughters and I were driving home on mountain roads, and around a sharp switchback, a drunk driver crossed into our lane and drilled us full speed. Luckily I had a good, wide angle, and he made contact right behind the driver's door. Everyone is fine. No one has a scratch. I have a slight concussion. This was in our primary driver: '03 Ford E350 Passenger Van. Totaled.
The '06 CRD has been sitting. I now have to get it going so we can have a solid driver, until we replace the van. Had some fuel delivery issues. It was the fuel filter.
Now, Water Pump pulley is spinning freely, in a bad way, no resistance, like a roller skate wheel.
A/C Pulley is crunky and difficult.
Running great, but getting too hot. Not showing up on temp needle on dash. Prolly bad thermostat too. Not driving it anymore until I get this part figured out.
Can Water Pump pulley be changed without changing the whole Water Pump? (Please say yes)
Can Water Pump be changed without doing timing belt? (Please say yes)
(Timing belt was already changed around 65,000 miles because of turbo failure, 6 rockers being crushed...you know, that old saw.)
Sorry I couldn't get more into the search bar. I did some preliminary research, but the concussion is making it hard for my mind to clamp down on so much information.
Thanks,
Randy