1.The correct Mopar name for the rubber connector hose between the air cleaner box and the turbo intake is:
"HOSE. Clean Air"
Part Number: 53013104AE
fits 2005 & 2006 Jeep Liberty
ID Parts list it as:
"Turbocharger Inlet Hose" (Liberty CRD)
OEM Part Number: 53013104AE
Manufacturer Number: 53013104AE
2. Most Jeep CRD owners add a ProVent coalescing filter model 200 between the CCV puck on top of the engine and the turbo clean air intake hose to keep the oil out of the hose and from accumulating in the bottom of the CAC (charge air cooler / intercooler). This will prevent the early deterioration and untimely rotting of the rubber inlet hose. They are available from several on-line suppliers, just do a google search for ProVent 200.
3. Turbo oil drain pipe or drain line comes off bottom of turbo housing and is routed down into the side of the engine block where it drains back into the oil pan as shown in this picture:
4. Turbo bearing oil supply feed line:
5. If your turbo boost hoses are being blown off; remove them, clean the inside of them good with some brake cleaner and a rag until you get all the oil off the rubber and the mating plastic surface where they attach. Put a small amount of contact or hi-tack glue on the mating surface and clamp the hoses back in place and let dry for a couple of hours. Hoses will not blow off again!
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve