It is currently Mon Dec 18, 2017 3:01 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 9 posts ] 
Author Message
 Post subject: Trans controler
PostPosted: Wed Sep 20, 2017 3:08 pm 
Offline
LOST Newbie

Joined: Wed Sep 20, 2017 2:50 pm
Posts: 1
Need a replacement to be programmed by greendiesel where can I get one for less then 150. .


Top
 Profile  
 
 Post subject: Re: Trans controler
PostPosted: Wed Sep 20, 2017 3:55 pm 
Offline
Lifetime Member
Lifetime Member

Joined: Sun Mar 28, 2010 9:15 am
Posts: 5271
Location: Tallahassee, Florida
Is the one you have broken? If not just mail it in USPS priority mail; 2 days out/2 days back.

FYI the electrical plug is on there REALLY tight.
1. when removing you may have to use a large bladed screwdriver to gently encourage/wiggle the plug to remove
2. CRITICALLY IMPORTANT do NOT attempt to reinstall by using the bolt to pull the plug into place. You will, I promise, spin the plastic nut the bolt screws into. Gently tighten the bolt and push/wiggle the plug further into place - repeat as needed.

_________________
Sold to LOST member my 05 Ltd, GDE Stg II turbo + TCM tune, SunCoast TC w. Transgo kit, Steiger window regulators, Samcos, Fumoto valve, 2nd gen filter head with Lub. Spec. bleeder, Hayden clutch & 11 blade fan, inverted spare, P-1 battery, BF Goodrich Long Trail TAs, Etecno1 glow plugs, timing belt at 50K miles/8 yrs


Top
 Profile  
 
 Post subject: Re: Trans controler
PostPosted: Wed Sep 20, 2017 4:25 pm 
Offline
LOST Member

Joined: Fri Jan 29, 2016 9:08 pm
Posts: 112
Location: East TN
I'm running a controller off of a 03 Ram.....probably can do a little searching to find out which years work. Same unit, just different shift points and pump pressure. I think GDE may be able to program them for the CRD.

_________________
2005 Sport CRD 130k
Yeti's Stage II DIY Hot Tune
Weeks stage 1&2 EGR Delete
Florida HD billet TC [500+flbs torque]
DIY T'stat Mod {Kap's design}
'03 Ram TCM


Top
 Profile  
 
 Post subject: Re: Trans controler
PostPosted: Wed Sep 20, 2017 10:19 pm 
Offline
LOST Addict
User avatar

Joined: Tue Jun 04, 2013 1:21 pm
Posts: 1831
Location: Utah
My Ram TCM was not able to be flashed by GDE to their eco tune, but for some reason they could flash it to the Pre-F37 OEM tune. No clue why. Other have had success and were able to get the RAM TCM flashed.

_________________
The Red Rocket-2006 CRD-400 ft-lb tune, Eco Trans Tune, Week's Kit, Mishimoto Hoses, Airtex Lift Pump, HDS Tstat, 2 Micron Racor, ARP's, OME 790's+top plate+clevis, JBA 2.5" rear+Iso, JBA UCA, Moab's, 265/70R16 Duratracs, ARB Bumper

2014 F150 EcoBoost


Top
 Profile  
 
 Post subject: Re: Trans controler
PostPosted: Thu Sep 21, 2017 8:38 am 
Offline
LOST Addict

Joined: Fri Jun 22, 2007 11:43 am
Posts: 3931
Location: Green Cove Springs FL
You could try getting a TCM from a 2005 Ram 1500 5.7 Hemi and use it while your CRD TCM is getting programmed by GDE.
I got my Ram Hemi TCM off ebay for $25.

_________________
Bought my '05 CRD on June 2nd '07, used with 29,000 miles.
intake elbow and EGR delete. 7 volt Etecno glow plugs
Yeti stage 2 ECU tune. Straight pipe exhaust. DIY intercooler hoses
Provent and modified factory 180F thermostat
Replaced cylinder head (cracked) at 160,000 miles + ARP studs
2.5 inch lift, 255-75-17 tires.
Still love it.


Top
 Profile  
 
 Post subject: Re: Trans controler
PostPosted: Thu Sep 21, 2017 2:25 pm 
Offline
LOST Newbie

Joined: Tue Oct 16, 2007 10:54 pm
Posts: 37
Location: VT
Just as a point of clarification: if you send GDE a RAM Hemi TCM and they can flash it with any Liberty program, it no longer has any RAM characteristics left. It would be the same as if you sent them a Liberty TCM in the first place. Still a cheaper way to go.

_________________
06 Liberty Limited CRD - homemade airbox intake, scotch-brite CCV + EHM, Weeks Stage 1+2, Yeti stage 2 ECM, GDE ECO TCM, FTC billet TC, Transgo kit, no mechanical fan, Cummins lift pump, 2.5" catback - OME 790/948 springs, JBA top plate, 3 upper rear insulators, Bilstein 24-139168 front, 24-186704 rear, 245/75R16, 1.25" wheelspacers


Top
 Profile  
 
 Post subject: Re: Trans controler
PostPosted: Fri Sep 22, 2017 5:55 pm 
Offline
LOST Addict
User avatar

Joined: Tue Jun 04, 2013 1:21 pm
Posts: 1831
Location: Utah
uncaged wrote:
Just as a point of clarification: if you send GDE a RAM Hemi TCM and they can flash it with any Liberty program, it no longer has any RAM characteristics left. It would be the same as if you sent them a Liberty TCM in the first place. Still a cheaper way to go.


They were not able to flash mine to their Eco Tune. They were able to flash it to the Pre-F37 stock tune for some reason. I ended up having to send them my Jeep TCM to get the tune loaded so now I have a Jeep pre-F37 TCM and GDE Eco TCM. People may want to confirm if they have successfully flashed the specific part # of the ram TCM you want to use.

_________________
The Red Rocket-2006 CRD-400 ft-lb tune, Eco Trans Tune, Week's Kit, Mishimoto Hoses, Airtex Lift Pump, HDS Tstat, 2 Micron Racor, ARP's, OME 790's+top plate+clevis, JBA 2.5" rear+Iso, JBA UCA, Moab's, 265/70R16 Duratracs, ARB Bumper

2014 F150 EcoBoost


Top
 Profile  
 
 Post subject: Re: Trans controler
PostPosted: Sat Sep 23, 2017 10:16 am 
Offline
LOST Member

Joined: Sun Mar 30, 2014 9:53 am
Posts: 283
mass-hole wrote:
uncaged wrote:
Just as a point of clarification: if you send GDE a RAM Hemi TCM and they can flash it with any Liberty program, it no longer has any RAM characteristics left. It would be the same as if you sent them a Liberty TCM in the first place. Still a cheaper way to go.


They were not able to flash mine to their Eco Tune. They were able to flash it to the Pre-F37 stock tune for some reason. I ended up having to send them my Jeep TCM to get the tune loaded so now I have a Jeep pre-F37 TCM and GDE Eco TCM. People may want to confirm if they have successfully flashed the specific part # of the ram TCM you want to use.


A few years back, I sent GDE a stock 2006 Liberty CRD TCM that I had bought from a salvage yard and a 2003 Ram hemi TCM that I bought on eBay. GDE flashed the CRD TCM with their ECO tune and it has been in my wife's Jeep since then. I sent the Ram hemi TCM for GDE to keep and experiment on. (I only paid about $25 for it). I figured if it could be flashed with their transmission tunes, the hemi TCMs would be a cheap source of programmable TCMs for CRD owners. I spoke with Keith a few months after I sent the TCMs. He told me the same thing. The Ram TCM I sent could be programmed with a stock CRD tune, but it would not take a GDE tune.

_________________
2006 CRD Sport
GDE FT ECO tune, GDE TCM ECO tune, ARP studs, HDS-001 203F T-Stat, 3.7L nylon fan & Hayden 2905 clutch, Carter P76148M in-tank fuel pump, Racor 245R122 filter head & 2 micron fuel filter, Provent 200, Samcos, Fumoto F-102, Litens 920834A de-coupler, PML rear diff cover, OEM trans pan with welded in bung, JBA UCAs, full skids.


Top
 Profile  
 
 Post subject: Re: Trans controler
PostPosted: Wed Sep 27, 2017 10:13 pm 
Offline
LOST Newbie

Joined: Wed Aug 13, 2014 4:27 pm
Posts: 95
I'm running the controller from an 02 gas liberty with the 45rfe. Was reprogrammed by GDE when I was there. Cost about 45.00 for the controller at LKQ self-serve.

_________________
Now have GDE full torque eco tune and eco transmission tune. Used an 02 liberty trans computer for my new trans tune.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 9 posts ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: Baidu [Spider], Git it Garage, Google [Bot], nexus6, PharmD and 12 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group. Color scheme by ColorizeIt!
Logo by pixeldecals.com