LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
trans dipstick grommet/oil cooler clip http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=87292 |
Page 1 of 1 |
Author: | 69Hcode [ Sun Oct 15, 2017 8:48 pm ] |
Post subject: | trans dipstick grommet/oil cooler clip |
I'm trying to find a good part number for a transmission dipstick tube grommet and the clips in the oil cooler line fittings. In the process of changing the dipstick tube and grommet on my CRD as it leaks when I back it into the driveway(facing downhill). I bent the tube trying to get it out. And Napa gave me a generic grommet that is too small. If you pull the engine mount from the right side and the crossmember under the trans you can get it out(with out bending it). I thought I was going to have to pull the trans out again. Just did the transgo kit and the torque converter a few months ago. I lost one of the clips for the cooler lines as well. Someone has had to have replaced these before. I'm going to call the dealer in the morning but I have very little faith in getting the correct parts from them. Any help would be appreciated. Thanks |
Author: | ebbnflow [ Mon Oct 16, 2017 2:47 am ] |
Post subject: | Re: trans dipstick grommet/oil cooler clip |
Not sure on the grommet, but I got the oil cooler clips from the Irish parts store. I brought one with me and was able to find them in a little pack. Getting that upper oil cooler line in was one of the most difficult parts of my trans R&R. Sent from my Pixel using Tapatalk |
Author: | WWDiesel [ Mon Oct 16, 2017 11:43 am ] |
Post subject: | Re: trans dipstick grommet/oil cooler clip |
69Hcode wrote: I'm trying to find a good part number for a transmission dipstick tube grommet and the clips in the oil cooler line fittings. Any help would be appreciated. Thanks Transmission Oil filler tube to Case grommet P/N: 04810021AB Google this P/N or go here:> https://www.factorychryslerparts.com/pr ... 021AB.html Transmission cooler line clips, there are two different styles in use (see diagram): #5. a metal clip that simply clips both metal lines together (may be more than one of these used?) #6. a plastic one that is anchored to stud on the engine oil pan. Both lines are clipped into this one and it slips over a stud on the bottom of the engine oil pan. Note: Some just simply split a short length of 3/8 rubber or fuel hose and sandwich it between the two lines and secure it all with some good tie wraps. |
Author: | AlGee [ Fri Oct 27, 2017 2:30 pm ] |
Post subject: | Re: trans dipstick grommet/oil cooler clip |
Had trans dipstick tube fatigue and break, got correct tube and grommet but didn't figure out how to route the new one in - thanks for the tip. |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |