Hey everyone,

Today I was in the process of replacing my Serpentine Belt, Alternator Decoupler Pulley, and my Tensioner Pulley, and the left sided Serpentine Belt Roller Idler bolt broke when I was tightening it back up. I was able to get the broken bolt part unscrewed and out of the hole, but now I need a replacement Serpentine Belt Roller Idler bolt.

Anyone know where I might be able to get one that will fit, and work just fine?

I guess I could just order a new Serpentine Belt Roller Idler (https://www.idparts.com/serpentine-belt-roller-idler-liberty-crd-p-2884.html) and it will likely have the bolt too.

Any suggestions?

Thanks in advance!

_________________
2005 Jeep Liberty CRD Limited: GDE Eco Tune, Weeks Kit 1&2, Provent 200, P3 E-Brake Controller, Custom Rock Rails, Suspension & Arms (OME, ARB, Raybestos, Bilsteins, etc.), 11-Bladed Fan, HD-Fan-Clutch, HDS M-001 Thermo, Fan-shroud-mod, Sasquatch Turbo, Tires: BFG AT TA KO2 LT245/70R16 - load D, Carter In-Tank Lift Pump.

If you have a fastenal local you can take the bolt there and if they dont have it they normally can get it in a few days. True value and or ace normally has a good selection but i havent found anyone who has more than fastenal personally.

_________________
Signature was too long, so follow the link below to view my Jeep specs until I can condense it.
https://justpaste.it/1f3y9

Thanks for the quick reply ryanchris!

I'll check them out tomorrow, there is a Fasenal about a 20 minute drive away, so me and the kids will be going on a Bus-ride!

_________________
2005 Jeep Liberty CRD Limited: GDE Eco Tune, Weeks Kit 1&2, Provent 200, P3 E-Brake Controller, Custom Rock Rails, Suspension & Arms (OME, ARB, Raybestos, Bilsteins, etc.), 11-Bladed Fan, HD-Fan-Clutch, HDS M-001 Thermo, Fan-shroud-mod, Sasquatch Turbo, Tires: BFG AT TA KO2 LT245/70R16 - load D, Carter In-Tank Lift Pump.