foxhunter wrote:
have a check engine light on, had the code read and it said "engine speed sensor malfunction". the guy at oreillys said it was the crank shaft position sensor. it was replaced 20000 miles ago and I have none of the symptoms as before. I think it is the map sensor may be a little plugged as a crank sensor usually doesn't throw a code and the vehicle quits.
you thoughts
tia
bob
They will occasionally trip a DTC when going bad and the ECM senses a loss of signal, a few have reported...
If you have an Autozone close by, they have the OEM Bosch part in their branded Duralast box for ~$50
Part Number: SU8492:>
https://www.autozone.com/engine-managem ... 793836_0_0
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve