Hello, I was troubleshooting a speed sensor problem and replaced both sensors. Not sure what I did but after troubleshooting a ground issue P1794 when I went to start the jeep it started for 2 seconds then died. Scanned the computer and got 13 engine codes.
Is the ECU toast?
Not for the faint of heart: P2295: Fuel pressure regulator 2 control circuit low (active) P2294: Fuel pressure regulator 2 control circuit open (active) P0091: Fuel pressure regulator 1 control circuit low (active) P0090: Fuel pressure regulator 1 control circuit open (active) P0489: EGR solenoid circuit Low - (active) P0047: Boost control solenoid circuit - (active) P1251: Vacuum Reservoir control circuit low - (active) P2141: EGR throttle control circuit low - (active) B10B3: Viscous cabin heater relay control circuit open - (active) P0480: fan 1 control circuit - (active) P0481: fan 0 control circuit - (active) P0670: Glow plug controller circuit - (active) P0660: System voltage - (active)
Good times,
dp
_________________ Purchased 2006 LIberty CRD 82K 01/16 SS Cat Back Exhaust, Full EGR Delete,Provent, Michelin 245/70 R16 AT/2 Stock Tune, Serpentine Belt Service,160 Amp Alternator 10/17 96K, New Head, Injectors, ARP Studs, HDS T-Stat 04/18 99K, New Reman Trans 09/18 104K, Lift Pump 01/19 106K, OME Lift, Eaton TruTrac LSD in new rebuilt diff
|