LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Pictures of my liberty crd
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=89074		 Page 1 of 1
Author:  Mopargarage [ Wed Aug 01, 2018 7:56 pm ]
Post subject:  Pictures of my liberty crd
https://ibb.co/nA3ife
https://ibb.co/cbxODz
https://ibb.co/hqO8fe
Author:  Mopargarage [ Wed Aug 01, 2018 8:04 pm ]
Post subject:  Re: Pictures of my liberty crd
https://ibb.co/h5DPLe
https://ibb.co/kHy26K
https://ibb.co/keFbYz
https://ibb.co/hXUaRK

I cleaned up a bunch of parts since I had to take everything apart to do the head gasket.
Author:  Mopargarage [ Wed Aug 01, 2018 8:12 pm ]
Post subject:  Re: Pictures of my liberty crd
https://ibb.co/gafX6K
Three of the 4 liberty crds that I own. The 4th liberty is a parts jeep. Eventually I'll pull the motor out and rebuild it.
Author:  flash7210 [ Wed Aug 01, 2018 9:33 pm ]
Post subject:  Re: Pictures of my liberty crd
What did you paint the turbo with?
Did the paint cook or peel off?

I’ve seen some super high temp paints before but they usually require some special prep and curing procedure.
Author:  Grotsoldaat [ Thu Aug 02, 2018 5:15 am ]
Post subject:  Re: Pictures of my liberty crd
Mopargarage wrote:
Image
Three of the 4 liberty crds that I own. The 4th liberty is a parts jeep. Eventually I'll pull the motor out and rebuild it.


And who is lurking under the tarpaulin..?
Author:  k9adv [ Thu Aug 02, 2018 8:12 am ]
Post subject:  Re: Pictures of my liberty crd
Very cool. Love the clean and painted engine.
Author:  TKB4 [ Thu Aug 02, 2018 9:07 am ]
Post subject:  Re: Pictures of my liberty crd
looks better than new , hopefully will run better than new for a long time {{
Author:  Mopargarage [ Wed Aug 08, 2018 1:16 am ]
Post subject:  Re: Pictures of my liberty crd
We just used spray bomb high heat paint for the turbo. The stuff said good for 800 degrees. So far I've only put on 10 miles since all the work was done. We will see how long it lasts. A 1980 cj 7 is under the tarp. Just went through the motor. It needs a full restoration. Has frame rust. I just had to do some work on the blue limited liberty in the picture.
Author:  Mopargarage [ Wed Aug 08, 2018 1:30 am ]
Post subject:  Re: Pictures of my liberty crd
So the electronic control valve was acting up on the blue limited. Had to swap it out with another one I had lying around. That one is running completely stock and has 220,000 miles.
Author:  Mopargarage [ Wed Aug 08, 2018 1:37 am ]
Post subject:  Re: Pictures of my liberty crd
The one I just did all the engine work should run fine now. I just got the egr delete update. Fixed the limp mode issue. Seems to be doing fine except for I think the rear main seal is leaking a little bit. I have the seal and tool to do it with. Just need to drop the trans one day and do the work. Should take me a couple days. I take a few breaks here and there.
Author:  TKB4 [ Wed Aug 08, 2018 12:39 pm ]
Post subject:  Re: Pictures of my liberty crd
I also have a 1955 willys cj5 with the f head engine with koenig power take off winch that will need some work before operational again . I have had it since 1978 used to drive it as main vehicle in college
Author:  Mopargarage [ Wed Aug 08, 2018 12:50 pm ]
Post subject:  Re: Pictures of my liberty crd
I will find a willy's one day :D
Author:  connolcj [ Tue Sep 18, 2018 11:45 am ]
Post subject:  Re: Pictures of my liberty crd
What did you use to clean and coat/paint your cam cover on the engine that painted red? Did you use a high temp paint or did you just clean up the aluminum and seal it?
Author:  Mopargarage [ Mon Oct 08, 2018 7:14 pm ]
Post subject:  Re: Pictures of my liberty crd
I just used regular aluminum spray bomb paint on the valve cover/camshaft assembly. I used high heat engine enamel for the block and head.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/