foxhunter wrote:
search wouldn't work so thought I would post an inquiry. check engine light is on but o'reilly's checked but there are no codes. is the crd different to where the scanner won't show all codes. I read some where that the dealer has a different reader that will pull the hidden codes. any experience with this ?
thx
Some of the less expensive scanners will not pull all codes. You will have to take it to a shop that has a very good scanner like a "SnapOn" or DRBII like the Mopar dealers have to get the codes. Some of the higher priced scanners may also show the codes.
You might want to try a different parts stores like AutoZone if you have one in your area, they may have a better scanner?
or
you may try this procedure:
1. Cycle the ignition key On - Off - On - Off - On within 5 seconds.
2. The odometer will show the P-code for the corresponding Diagnostic Trouble Code number.
3. If no DTC's are present, the cluster should display: "done"
"Done" indicates that no DTC's are present and the procedure is complete.
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve