So the other week my headlights stopped working - low beams only everything else works. I replaced the multi function switch on the steering column and that did not work so maybe it's a relay? I thought there was a sticky on this forum with all of the diagrams but maybe I am not seeing it? Any help here is very appreciated!

check out the noob guide and look for the service manuals.

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic

Thank You Sir Sam that is what I was looking for!

There are separate fuses for high and low beams...wiring diagrams will show which fuses.

The High Beam Relay is the small relay on the internal fuse panel (Junction Block)....Low Beam Relay is on the reverse side of the Junction Block....the locations section of the Wiring Diagrams will show which of the several relays on the Junction Block is the Low Beam Relay.....swap relays over if not a blown fuse. Gets a bit more complicated if you have Daylight Running Lights as in Canada.

_________________
2002 Export CRD