One of my crd liberties has an oil leak which I'm pretty sure that the rear main but I have coolant mixing in the bell housing with the oil. The transmission is out, flywheel and adapter removed. I just need my flashlight to recharge and I'm headed back under there to take another look. It was hard to see earlier with a dying flashlight. I will pressurize the coolant system and see what happens. Has anyone experienced this before?

Need more info.....

_________________
'06 Lbrty Sprt CRD 150K

Sasquatch
DSS Turbo
CAT-elimntr
Weeks Stg1&2 EGRfix
PV-200
BLING
vent gauges

IDParts
head
cams
rockers
Timing set
ARP studs
eTn1 GX2123 5v GPs

YETI Custom Tune
Flowmaster 8325508
Carter P76611M
GM 12611872
Hayden 2986
GM 15976889
PATC Custom Billet
2010 Ram Hemi Trans
Sonnax 44957
Transgo kit
Cooper 51770

I couldn't find my pressure tester but it looks like where there's 4 bolts around the seal that 2 of the bolts heads have somehow been sheared off. Didn't have my phone on me to take a picture at the time. I'll take one in the morning. No sign of cracks that I could visually see.

It turned out the coolant was leaking from a hose underneath the coolant reservoir. Then it went down the side of the bellhousing making me think it was coming from the block. The rear main seal was shot though.