Hi all, while checking glow plug resistance due to a P1267 code (verified #4 is bad), I noticed a two wire (BR/OR and BR) green male electrical connector near the glow plug controller that is unplugged with nothing in site that I can see to plug it in to. In looking at the service manual it appears it is either for the fuel pressure solenoid (not probable as I would assume it would not run with that unplugged) or the water in fuel sensor. When I just replaced the fuel filter there was not a sensor on the bottom so maybe that it is but would like a more sr CRD owners help to verify.
One of the wires is broke as well, I can see the wire that is broke.
Attached are a couple pics.
I just got the 2005 liberty limited a couple weeks ago and learning a lot about this engine/vehicle.
thanks
Rifleman