| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Need help with torque converter replacement. http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=89912 |
Page 1 of 1 |
| Author: | jaffazoom [ Fri Apr 12, 2019 1:57 am ] |
| Post subject: | Need help with torque converter replacement. |
Hi Guys. I know this has been done over and over and I've read a heap of opinions on this but my buying options are limited in Australia. So I can get a Florida Torque Converter off ebay with cheap shipping to here. Only 2 being advertised are the 13-35LSSD at around $1100 AUD or a 13-37 for $600AUD. No one lists the 13-36 which is the base converter for the Liberty CRD. Will the 13-37 fit, is it the same as the one people use when using the hemi converter? Only difference I can see is it has a lower stall which should be a good thing. By the time I do the pump and a Trans-go kit I'll end up around $1100 if I can use the 13-37. Any help appreciated. |
|
| Author: | Science and Energy [ Mon Apr 15, 2019 9:41 am ] |
| Post subject: | Re: Need help with torque converter replacement. |
I got the 13-35LSSD. It is the "bigger better" replacement. I haven't put it in yet. Send them a message or call them. They were very responsive when I asked questions. |
|
| Author: | geordi [ Mon Apr 15, 2019 1:23 pm ] |
| Post subject: | Re: Need help with torque converter replacement. |
I installed the 13-35SD, lower stall non-billet converter, and I'm very happy with it. The "base" converter is not the 13-36, it is the 13-35. But as these are all for the 545RFE, technically they will all fit. How they perform with changes to the vane angles or spring rates or whatever else they change... I couldn't tell you. I would try contacting Florida Torque Converter directly, they were very helpful when I got mine. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|