| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Rear drive shaft part # http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=90010 |
Page 1 of 1 |
| Author: | timothyd [ Sat May 11, 2019 5:59 pm ] |
| Post subject: | Rear drive shaft part # |
I have a high speed vibration, there is nothing until about 65 and it gets even worse over 70, it is at this point undrivable at those speeds. I believe I may need to replace the whole rear drive shaft, there is what feels like some slop where the shaft slides onto the output shaft, both ujoints are tight with no slop but the weights are peeling off and the balancer looks pretty crusty. Things I have ruled out: All four wheel bearings are tight with no play up and down (rear does have in and out) All four new rotors and pads, all four wheels spin free from the breaks Front drive shaft is brand new (was blown apart when I bought it) All bushings are tight, just had the rear lower control arms replaced under recall All CV joints are tight and boots are good All four tires are 5K pretty much new tires All four new TPMS sensors and then re balanced wheels The wheels are the only other concern, this jeep was abused a bit when I got it, some minor front end damage and peeling bedliner on the wheels, they *could* be damaged but there is no outright visible bends in the wheels at this time. |
|
| Author: | ebbnflow [ Sun May 12, 2019 1:58 pm ] |
| Post subject: | Re: Rear drive shaft part # |
Have you removed the rear drive shaft to check the u joints? They can seem tight while the shaft is installed. Sent from my Pixel 3 using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|