| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Head off TDC http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=91844 |
Page 1 of 1 |
| Author: | timothyd [ Tue Feb 02, 2021 7:49 pm ] |
| Post subject: | Head off TDC |
This may seem like a silly question but I took the head off without the pins in. I am going to install the head soon and I am assuming all three pins can only go in one way is that correct? |
|
| Author: | PZKW108 [ Tue Feb 02, 2021 8:14 pm ] |
| Post subject: | Re: Head off TDC |
timothyd wrote: This may seem like a silly question but I took the head off without the pins in. I am going to install the head soon and I am assuming all three pins can only go in one way is that correct? No, it's possible to put the fly wheel pin wrong, It can be 108 degrees out. Also with all the pins in properly I think you will be 90 degrees past TDC. |
|
| Author: | timothyd [ Wed Feb 03, 2021 6:50 pm ] |
| Post subject: | Re: Head off TDC |
So the two cam pins can only go in one way, where are the pistons supposed to be when it is locked in? |
|
| Author: | WWDiesel [ Wed Feb 03, 2021 10:00 pm ] |
| Post subject: | Re: Head off TDC |
timothyd wrote: So the two cam pins can only go in one way, where are the pistons supposed to be when it is locked in? all 4 pistons will be at half travel if you have the crankshaft in the correct 3:00 position and pinned as shown below and described in the Factory Service Manual.  In correct position for crankshaft and both camshafts pinned: 
|
|
| Author: | timothyd [ Thu Feb 04, 2021 12:39 am ] |
| Post subject: | Re: Head off TDC |
Thank you WWDIESEL!! Your a legend as always. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|