LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Front differential bushing problem
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=91846		 Page 1 of 1
Author:  giacomo.m [ Thu Feb 04, 2021 4:28 am ]
Post subject:  Front differential bushing problem
Hi all,

for a 2002 KJ 2.5 CRD I am looking for the 4 bushing for the 3 supports of the front differential ,which have the following part numbers : 52059473AE - 52059472AC - 52059475AD
it seems that 2 in particular are not found and are no longer produced ...
do you know of some adaptable aftermarket spare parts or some bushing that can be mounted ?
thank you

Giacomo
Author:  giacomo.m [ Fri Feb 05, 2021 3:25 am ]
Post subject:  Re: Front differential bushing problem
Good morning,
nobody knows anything about it and can you help me ?
thank you

Giacomo
Author:  WWDiesel [ Fri Feb 05, 2021 4:33 am ]
Post subject:  Re: Front differential bushing problem
Just a thought, since they are discontinued by Mopar and no one else seems to list them. :banghead:
Get some used ones from a donor
or
you could try the DIY polyurethane bushing method?
Look on YouTube, lots of videos on how to. :wink:
Good luck,
Author:  giacomo.m [ Fri Feb 05, 2021 8:22 am ]
Post subject:  Re: Front differential bushing problem
Thank you WWDiesel

in fact, knowing the bushing sizes, you could look for them aftermarket ...

Giacomo
Author:  DenofDogs [ Sat Feb 27, 2021 8:41 pm ]
Post subject:  Re: Front differential bushing problem
I have done all 4 front mounts with after market urethane bushings with DOM tubing OD and ID. I had to turn the OD of the DOM tubing from 2" to approx. 1.87" to make it a press fit in the old mounts.
Old mounts need to be pressed out. The main symptom was lots of slop in the front drivetrain when putting in 4WD. The front drive shaft would almost torque down and touch the cross member.
The entire job was a lot of work, but no metal on metal noise over small bumps on rough roads now.

If there is interest, I will do a write up with PN's, sizes etc.

Thanks,

Jim
2006 CRD sport, 4WD, 228,000 miles
Author:  giacomo.m [ Sun Feb 28, 2021 3:34 am ]
Post subject:  Re: Front differential bushing problem
Hi DenofDogs meanwhile thanks for your interest
it would be ideal to know PN's,sizes and write up
thank you

Giacomo
Author:  DenofDogs [ Sun Feb 28, 2021 10:51 pm ]
Post subject:  Re: Front differential bushing problem
Giacomo,

I will work on the write up this week. Now that I have the front end tight I can get and alignment and new tires.

Thanks,

Jim

PS. to replace the front axle/differential mounts is much work to warn you ahead of time.
Author:  giacomo.m [ Mon Mar 01, 2021 3:22 am ]
Post subject:  Re: Front differential bushing problem
Jim thanks to you
I'm waiting the write up

Giacomo
Author:  DenofDogs [ Mon Mar 01, 2021 8:54 pm ]
Post subject:  Re: Front differential bushing problem
Giacomo,

Please PM me your email so I can send you what I have written up so far. I have it saved as a .PDF file. Not sure how to submit on Lost Jeeps as a writeup.
Here is a link to where I got the bushings from.
https://www.ruffstuffspecialties.com/mm ... de=R1087-A
Thanks,
Jim
Author:  WWDiesel [ Mon Mar 01, 2021 10:21 pm ]
Post subject:  Re: Front differential bushing problem
DenofDogs wrote:
Giacomo,
Please PM me your email so I can send you what I have written up so far. I have it saved as a .PDF file. Not sure how to submit on Lost Jeeps as a writeup.
Here is a link to where I got the bushings from.
https://www.ruffstuffspecialties.com/mm ... de=R1087-A
Thanks,
Jim

Send me the pdf file using the email button and I can post it for you.
Author:  giacomo.m [ Tue Mar 02, 2021 3:12 am ]
Post subject:  Re: Front differential bushing problem
Jim,

my email: meraviglia.g@gmail.com
thank you

Giacomo
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/