So one of my old keys broke, and I ordered a couple of new ones off Ebay. I've been trying to program them unsuccessfully so far and though I'd check with the folks here on how to do it. This is an 06 CRD with EVIC. This is what I have tried so far:
In the 06 service manual they say there should be a Train Remote option on the EVIC, right after Service Interval. Well no such option on my EVIC. Unless there is some secret button push you need to get into it (let me know if there is).
I have tried the sequence at the last post on this thread
viewtopic.php?f=5&t=90281 I never get a chime when it is supposed to enter programming mode, after step 3. And if I just continue on as though it worked, none of the new remotes are programmed. So I am guessing I did not enter programming mode.
I have looked in the FSM for instructions, but they only say do it thru the EVIC entry I don't get, or via the scan tool. At least that I have found.
At this point I think it is too soon to blame the new keys, since it does not seem that I have gotten into remote program mode yet. Anyone know a programming sequence that works, or the secret key presses to get to the Train Remote selection on the EVIC?
TIA