Hi all,
Can someone give me a measurement of the OEM 2006 Liberty CRD oil dipstick length?
I just changed oil and filter. I put 6.3qt of oil in and ran the engine for a few minutes and let it sit for 4 hours.
When I tried to check the oil level, I don't see any oil at the bottom of the dipstick.
Either there's a blackhole inside the diesel engine or the dipstick is too short.
Yes, it's on level ground. Please share the length of your 2006 CRD oil dipstick. Thank you.

Run the engine a few minutes then shut it off for a few minutes and check the oil.

Do not wait 4 hours !

No luck. It has some oil on the edge of the dipstick (same as before, I forgot to mention it), but nothing at the bottom.
Could you please measure how long your engine oil dipstick is? Thanks.

Did you take into the account for the oil it took to fill the filter?

_________________
GDE FT Ecotune, EHM, Weeks kit stage 1 & 2, Carter 4600 lift pump, Upgraded tranny, Fishing boat hauler!
New at 164K: head gasket, rockers, exhaust valves, ARP head studs, Injectors, 5v Bosch glow plugs, water pump, timing everything, serpentine everything,
New at 225k: new head, timing belt

Here you go, hope it helps?

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve

@WWDiesel
Thank you so much.