I'm replacing the left & right front axle bushes on my 2005 2.8crd Liberty & have run into a parts issue,
The right side bush/bearing is the correct size as supplied by jeep but the Left side the bush ID is 1mm larger than the right as it has a larger axle.
Standard bush 5066056AA Axle Shaft Bearings size is: ID 34.925mm / 1.375". My left size axle measures 35.925mm / 1.414"
Any ideas whats going on here & where can I get the correct bush for the larger axle?
As far as I can see all the parts lists only show 1 p/n for both left & right sides

When I refreshed/installed my ARB locker in the front diff, I put in both needle bearings (part number 05066056AA) for the left and right side and I have not had any problems. I later swapped out my CV axles for the trakmotive heavy duty extended travel axles (for increased articulation) and they slide in with no problems.

_________________
05 CRD; Rebuilt top end w/ARP studs, EGR delete, SEGR, 3.7L HD cooling fan, Samco hoses, in tank pump, JBA coil overs & control arms, KK clevis fork, 1/2" cradle drop, 1/4" motor mount lift, WJ rear upper trilink w/WW mount, WJ lower control arms, 4:10 gear, front/rear air lockers, ARB bumper, Rock Lizard sliders/roof rack, Mod T-stat