| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Axle shaft bearing size, Standard bushes dont fit both sides http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=92844 |
Page 1 of 1 |
| Author: | yetiboy01 [ Fri Jan 05, 2024 2:22 am ] |
| Post subject: | Axle shaft bearing size, Standard bushes dont fit both sides |
I'm replacing the left & right front axle bushes on my 2005 2.8crd Liberty & have run into a parts issue, The right side bush/bearing is the correct size as supplied by jeep but the Left side the bush ID is 1mm larger than the right as it has a larger axle. Standard bush 5066056AA Axle Shaft Bearings size is: ID 34.925mm / 1.375". My left size axle measures 35.925mm / 1.414" Any ideas whats going on here & where can I get the correct bush for the larger axle? As far as I can see all the parts lists only show 1 p/n for both left & right sides |
|
| Author: | 03black [ Fri Jan 05, 2024 1:05 pm ] |
| Post subject: | Re: Axle shaft bearing size, Standard bushes dont fit both s |
When I refreshed/installed my ARB locker in the front diff, I put in both needle bearings (part number 05066056AA) for the left and right side and I have not had any problems. I later swapped out my CV axles for the trakmotive heavy duty extended travel axles (for increased articulation) and they slide in with no problems. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|